When
shopping, take this checklist with you to compare features!
Ask
these questions, mark the answers, and look at the results.
Watertech is the Best Value in the Whirlpool
Bath industry!
| Does
the Whirlpool Bath have these features? |
Watertech |
|
|
|
Automatic
Air Injectors
|
|
|
|
|
Structural
Steel Base to reinforce the bottom floor
of the tub and hold motor
|
|
|
|
|
Fully
adjustable large Spa Jets (16 gallons of
water flow per minute)
|
|
|
|
|
Thick
.125 and .157 Acrylic
|
|
|
|
|
Custom
Colors
|
|
|
|
|
Rigid
Sch. 40 PVC Piping
|
|
|
|
|
Custom
Pump and Jet Locations
|
|
|
|
|
2
h.p. Whirlpool Pump Powered by a GE Motor
|
|
|
|
|
No
Discontinued Parts
|
|
|
|
|
U.L.
Approved
|
|
|
|
|
Foam
Packaging
|
|
|
|
|
|
The
"DOs and DON'Ts" of receiving and installing
your new Watertech Whirlpool Bath:
In
order to assure that your new Watertech Whirlpool Bath
is properly installed and warranteed,
be certain to follow these procedures when taking delivery
of and installing your new tub.
1.
Before signing for delivery, do a comprehensive visual
examination of your new tub to check for any damage
and to make certain all parts are in your shipment.
If problems are found, notify your sales person BEFORE
signing invoice.
2.
Never allow your tub to be lifted or carried
by the pipes.
3.
BEFORE INSTALLING INDOORS, do a water test OUTSIDE:
Fill your tub to approximately 2" above the highest
jet. Turn tub on to check for any leakage. If any
problems are found, notify your sales person immediately.
4.
Cement mortar MUST be used by your contractor beneath
the tub bottom as codes require in order to allow for
a rigid tub bottom.
5.
Be certain that once your tub is installed, you have
adequate access to the pump assembly. Make one final
water check for leaks before final tub enclosing.
IMPORTANT!
BEFORE INSTALLING, READ AND REVIEW ALL INSTRUCTIONS
WITH YOUR CONTRACTOR.
|
|
User
Maintenance Instructions
Periodically
clean and disinfect inner walls of pipes with dishwasher
soap or household bleach. Fill tub with warm water and
add 1 cup of either of above products. Run system for
5 minutes. Let soak for a minimum of 20 minutes, then,
before draining, run system an additional 5 to 10 minutes.
Drain bath completely, refill with cold water, turn
on for a few minutes and drain.
|
